Company news
Industry news

       In order to ensure the quality of fiberglass desulfurization tower, the proportion and quantity of dust should be considered first, which is the precondition to determine the power and capacity of vacuum equipment.Generally speaking, the power and capacity of the selected equipment are higher than the actual demand;In addition, dust humidity is a condition that determines whether to choose dry or wet cleaning equipment.If it is dry cleaning equipment, it cannot be used to absorb liquids or high humidity.
       Control technique of specification and quality standard of FRP desulfurizer
       1, determine the requirements and technical requirements of desulfurization tower, mainly considering the following points:
First, consider the proportion and quantity of dust, which is a prerequisite for determining the power and capacity of vacuum equipment.Generally speaking, the power and capacity of the selected equipment are higher than the actual demand;In addition, dust humidity is a condition that determines whether to choose dry or wet cleaning equipment.If it is dry cleaning equipment, it cannot be used to absorb liquids or high humidity.
       2. Frequency and working time of the desulfurization and dust removal machine shall be adopted. The machine shall be used continuously for 24 hours and the general industrial dust removal equipment shall be used for continuous operation for 24 hours.
       3. Judge the environmental cleaning grade from the working conditions and environment, and whether the dust collector is used in the clean room.
       4, according to whether flammable and explosive work conditions, according to the safety level to determine the need for explosion-proof industrial dust remover.
       Do not pull the power cord. If you see a yellow or red label on the power cord, stop pulling immediately to prevent pulling the cord.If you need to scroll back to the power cord, press the button to retrieve it automatically.
       Pay attention to the installation and preparation of the dust collector before installation
       1) in addition to the size of the foundation, the basic quality should be inspected and installed after qualified.
       2) the dust collecting box, box body, bellows and bellows in bags should have good sealing performance among each part, and each part should be tested with kerosene penetration method.
       3) air tightness test shall be conducted on the pipes of the system and joints of each group.
       4) calculate each parts list, and confirm whether the parts are lost according to the parts list listed in the list. The parts on the list have little contact with the company, so as to install the required parts as soon as possible and have complete equipment.