In the process of chemical enterprise production will produce large amounts of organic waste most of them can use a conventional biochemical or physical method to deal with, but there are still a small amount of waste water treatment method with traditional discomfort, waste incineration is a good plan I waste liquid incinerator based on the characteristics of various kinds of wastewater professional design company, strong pertinence.
Waste liquid furnace Process flow diagram 
The characteristics of waste liquid Incinerator/Incinerator
1. Adopt mixed dual-fluid atomizer inside tangential atomizer, which has high mixing degree, atomization effect, combustion speed and efficiency, low excess air coefficient, and can save a lot of fuel.Adopt low pressure spray, safer than high pressure spray gun, not easy to wear, not easy to fault, good combustion effect, atomizing medium can be low pressure steam or air;
2. High combustion safety. The control logic program is equipped with the function that ignition cannot be performed without excluding explosive gases before ignition in the furnace to prevent gas explosion;Equipped with flame detector, in case of flameout or ignition failure in the furnace, automatically cut off the supply of oil and waste water immediately, the alarm system is perfect, safe and reliable;
3, according to the composition and characteristics of waste water, design different shapes and lining incineration furnace body;According to the situation of salt in waste water, different furnace temperature control methods are designed to ensure that the inorganic salt does not hang on the wall in the furnace when burning, and rarely form salt fog out of the furnace;Dust and acid gas generated in the incineration process shall be treated in the most economical and reasonable way to fully ensure that no new pollution will be generated after the incineration:
4, full consideration of waste liquid incineration waste heat recycling, can produce steam, hot water, hot air or heat conduction oil for production and life use;
5. The waste water incinerator can treat organic waste gas and a small amount of solids while treating waste water
6, combustion stability, high safety, automatic control, easy operation and maintenance;
7. Furnace combustion is designed according to the principle of 3TIE I temperature, time, eddy current and excess coefficient to ensure the full oxidation, pyrolysis and combustion of waste liquid in the furnace combustion chamber.The removal rate of organic matter reaches 99.99%
8. Equipped with a complete tail gas treatment system to ensure the tail gas standard emission.
This product is Applicable scope
1. Non-flammable high concentration wastewater, waste liquid, organic acid, organic alkali, etc
2, combustible waste liquid, solvent, etc.
Telephone: 0510-80731188